Toshiba Satellite Pro S200 User Manual page 78

In all instances you should shut down the computer and remove the
incompatible module(s).
Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.
Installing a memory module (Slot A and Slot B)
The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the
Chapter 1, Getting Started if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
the
Up Modes, if required).
4. Loosen the screw securing the memory module cover in place - please
note that this screw is attached to the cover in order to prevent it from
being lost.
Use a point size 0 Phillips screwdriver.
5. Slide your fingernail or a thin object under the cover and lift it off.
Screw
User's Manual
Replacing the battery pack
Figure 3-6 Removing the memory module cover
Hardware, Utilities and Options
Turning off the power
section in Chapter 6, Power and Power-
section in
Memory module
cover
3-20