Saeco 0347.0CH.77E User's And Maintenance Booklet page 10

43
38
coffee quantity according to the cup dimension.
By means of the 3 selection keys
desired coffee quantity can be chosen. The
display shows the selected quantity.
Cup level adjustment
To set the quantity of coffee to be dispensed,
press the selection key corresponding to the
right quantity and keep it pressed while the
coffee is dispensed into the cup. Release the key
only when the right level has been reached
(max. 250 ml approx.). As soon as the dosage
programming mode gets activated, the display
shows:
"1 SMALL COFFEE
"PROGR. QUANTITY "
Warning! If activated, the pre-brewing function
will be performed.
Double quantity of coffee
i.e. 2 cups of coffee
If one of the three selection keys (no matter
which one) is pressed twice before coffee
brewing, the machine will brew a double
quantity of coffee.
Coffee beans
29
This machine grinds a portion of fresh coffee for
each cup; for two cups, it grinds two portions of
coffee, one after the other thus ensuring opti-
mum coffee quality.
Before any use, make sure the steam/hot water
knob is closed.
Man. Titan 0313.959 ING (UL) 7
BREWING
Adjust the desired grinding degree: the recom-
mended average value is 5.
the
The grinding degree must be adjusted only
when the coffee grinder is operating, otherwise
it may be damaged.
Place one or two preheated cups on the grill (3)
under the dispenser (6). Press the relevant
selection key. The machine will automatically
dispense the selected coffee.
The coffee flow may be stopped at any moment
by pressing any selection button (except the
standby switch), for instance when an excessive
quantity of water has been selected. Should you
interrupt the coffee flow after the first of two coffees
"
has been brewed, the second is not dispensed.
Pre-ground coffee
Make sure to use pre-ground coffee only (me-
dium ground). Never use whole beans or
soluble coffee!
Right before making coffee, fill the container
with freshly ground coffee. Remember that
ground coffee ages soon, thus losing its quality.
30
Use the measuring spoon supplied to fill the
container (14) with ground coffee. Use a full
measure only.
Then, press the pre-ground coffee selection
button and the desired selection key (regu-
lar, espresso or tall coffee) to obtain a cup of
coffee. It is not possible to obtain a second cup
44
39
of coffee.
The coffee flow may be stopped at any moment
by pressing any selection button (except the
standby switch), for instance when an excessive
quantity of water has been selected.
Hot water
The hot water dispensing is separate from the
coffee circuit, in order to supply tasteless hot
water for tea, soup etc.
31
Place a glass or cup under the steam/hot water
dispensing tube (7), then slowly open knob (9),
turning it counterclockwise. Hot water will be
automatically dispensed. As soon as dispens-
ing is over, close knob again.
Steam
To heat milk or other drinks.
Clean the spout with a damp cloth soon after
use; otherwise, it might be difficult to remove
milk residues.
After a steam outflow, always drain the ma-
chine. If the machine is not drained or drained
partially, the coffee brewing program automati-
cally stops, due to excessive temperature.
If the machine is on the steam mode , the
automatic coffee brewing is prevented.
12-12-2000, 16:09
BREWING
"STEAM "
"WARMING UP...... "
Press the steam selection button and wait
until the machine reaches the operating tem-
perature.
"STEAM "
"READY FOR USE "
Operating temperature has been reached.
Direct the steam/hot water dispensing tube (7)
over the cup holder grill (3) and slightly open
knob (9), turning it counterclockwise.
Wait until the remaining water has flown out of
the spout. Then move the spout outwards and
immerse it into the fluid to heat.
32
Slowly open the steam/hot water knob and
heat the fluid using a circular movement from the
bottom to the top.
When the fluid has reached the desired tem-
perature, close the knob and immediately clean
the spout with a damp cloth.
Warning: the spout is hot, it may cause burns!
If you are not going to use the steam/hot water
dispensing tube any longer, position it over the
cup holder grill and disactivate the steam func-
tion by pressing the key .
"OVERTEMPERATURE "
The machine stops working and does not brew
coffee. Let it cool down or open the steam/hot
water knob again.
"HOT WATER "
"OVERTEMPERATURE "
Drain the machine (the pump starts automati-