Mounting Pattern For Pm2014 Lathe - Powermatic PM2014 Operating Instructions And Parts Manual

4.1 Mounting pattern for PM2014 Lathe

If you are not using the accessory Powermatic stand, use this hole pattern in your workbench for securing the
PM2014. Workbench holes will be clearance holes for 5/16" screws.
Holes in lathe base are threaded 5/16"-18, 3/4 in. deep. Only four of the holes need be used when mounting to
a workbench.
Use four 5/16"-18 bolts of appropriate length with washers; insert through workbench and into lathe base.
Figure 4-1: mounting pattern for workbench
8