Advertisement
7.9.
dust ColleCtor
7.9.1.
The SM100 is equipped with a dust collector provided with a 35mm Ø outlet for connection to your own dust extraction system (fig 13).
warnInG! dust produced by this operation may be hazardous in which case use a dust mask.
‰
8. maIntenanCe
warnInG! ensure the sander is switched off and unplugged from the mains power supply.
‰
oVerload swItCh
8.1.
8.1.1.
Should the sander motor be overloaded an overload switch will activate cutting the power to the machine. If this happens allow the
motor to cool. The overload switch is located on the main contactor underneath the switch cover.
8.2.
belt replaCement
8.2.1.
Turn the belt tension lever to "loosen".
8.2.2.
Remove the two screws in (fig 14), open the belt cover and remove the used belt.
8.2.3.
Place the new belt over the end rollers (fig 15).
8.2.4.
Re set the belt tension lever by turning it to the "tighten" position.
8.2.5.
Rotate the belt by hand whilst checking and adjusting the tracking.
8.2.6.
Check and adjust the belt tension accordingly.
fig 13
fig 15
weee reGulatIons
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
enVIronment proteCtIon
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey Group, kempson way, suffolk business park, bury st edmunds, suffolk. Ip32 7ar
01284 757500
© Jack Sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig 14
www.sealey.co.uk
SM100 | Issue:3 (H,F) 13/09/18
Advertisement
