Rear Panel - Philips VR288/55 User Manual

20 STOP 7 / ∞ ∞ ∞ ∞ ∞ button
• Stops the tape. ( P.14)
• Moves down the cursor when using
the menus. ( P.11)
21 CH (channel) 5 / ∞ button
Before using this button, press VCR or
TV.
• After pressing VCR, changes the
channels on the VCR. Release at a
desired channel.
(For some PHILIPS TV only):
• After pressing TV, changes the
channels on the TV. Release at a
desired channel.
22 VOL (volume) 5 5 5 5 5 / ∞ ∞ ∞ ∞ ∞ buttons
(For some PHILIPS TV only):
Changes the TV volume.
Release at desired volume.
23 CLEAR button
Erases unwanted timer programmes.
( P.18)
24 AUDIO/MUTE button
(For some PHILIPS TV only):
Turns off the TV sound.

Rear Panel

1
1 AC (alternating current)
power cord
Connect the AC power cord to an AC
outlet.
2 AUDIO IN (input) jack
For connecting to the audio output jack
on another VCR or a portable video
camera. ( P.19)
VR288/488-55 EN (N)
To insert the batteries:
1
Remove the battery compartment lid
from the bottom of the remote
control.
2
Install two batteries —R6(SUM-
3)/AA — matching polarity
indicated inside the battery
compartment.
3
Replace the lid.
AUDIO
VIDEO
3 AUDIO OUT (output) jack
For connecting to the audio input jack
on a TV or another VCR. ( P.9)
4 ANT. (antenna) IN (input)
terminal (from Antenna)
Connect your antenna or Cable to this
terminal. ( P.9)
— 7 —
7
Note:
This remote control and batteries are
supplied accessories.
Check to make sure they are included.
Also, check "Specifications" to see what
other accessories are included.
CAUTION
On Battery Replacement
Do not mix old and new batteries.
(Also never mix alkaline batteries
with manganese batteries.)
2 3
4
5 VIDEO IN (input) jack
For connecting to the video output jack
on another VCR or a portable video
camera. ( P.19)
6 VIDEO OUT (output) jack
For connecting to the video input jack
on a TV or another VCR. ( P.9)
ANT.IN
IN OUT
7 RF OUT (output) terminal (to
TV)
RF OUT
Use the supplied RF coaxial cable to
connect this terminal to the UHF/VHF
input terminal on the TV. ( P.9)
6 7
5
5/31/99, 3:15 PM