Accessing An Nfs Export - Dell EqualLogic FS7500 Installation And Setup

EqualLogic FS7500 Installation and Setup
• Enter
\\service_ip_address\share_name
• Click
Connect using a different user name
5. In the Connect As dialog box, enter a valid user name and password, then click OK. Note that you can enter
CIFSstorage\administrator for a user name and the CIFS password that you set previously.
The user can now log in to the CIFS share and perform read and write operations. The default permission is to
disallow guest access. You can modify the share to allow guest access.

Accessing an NFS Export

If you plan to use NFS over UDP, do the following first:
1. Adjust the firewall to allow the FS7500 controllers to be the source IP.
2. Open the firewall to allow for port ranges.
To mount an NFS export on a UNIX system, log in as
recommended options and parameters.
Note: While the command example shows the recommended parameters, you can change the protocol to UDP
and the NFS version to 2.
mount -o rw,bg,hard,nointr,tcp,vers=3,timeo=2,retrans=10,rsize=32768,wsize=32768
client_access_vip
:/
The
exported_directory
Because the default trusted user setting is "All except root," only users other than
You can modify the export and change the trusted users to "Nobody" or "All."
In addition:
• The default client access permission provides access to all clients. You can modify the export and limit
access to specific IP addresses.
• The default access type is read-write. You can modify the export and change it to read-only.
66
exported_directorylocal_directory
must be the full path name that you specified when creating the NFS export.
.
.
and run the
root mount
6 NAS Storage Allocation
command with the following
can access the export.
root