Morphy Richards MRPB20B Instruction Manual page 8

NOTE: If the blades become blocked or are otherwise not able to turn freely, the product will stop
immediately and the white LED indicator will flash. Whilst the light is flashing, the product will not
respond to pressing the button switch. Clear the blades by flipping the unit gently and wait for the
light to stop flashing before attempting to begin the blending process again.
2. Press the power switch at any time during the blending process to stop the machine.
3.
In order to protect the motor, the blender is programmed to run for 40 second intervals. If the
motor does not shut down after 40 seconds, turn off manually by pressing the power switch
and restart as required. At full charge, the blender can be operated 5 times (at approx. 3
minutes per use) with recharge being required again after the 5
NOTE: Any fruit and / or vegetables placed into the blending cup should be washed, peeled and
cut into small cubes of approx. 1cm.
4. Put the cut fruit / vegetables into the blending cup, add water or your preferred milk or other
liquids.
NOTE: The total amount of food and liquid should not exceed the maximum mark (300mL) of the
cup.
5. The motor assembly should be twisted into position on the blending cup and hand tightened
in place to ensure that the food will not leak out.
6.
Double-click the power switch on the motor assembly, turn the product upside down, hold it in
hand, and the product starts to work.
NOTE: During the blending process, you may click the power switch once, and the product will
stop working immediately. If the blade is stuck at start-up, the product can be placed upright and
then placed upside down after normal start-up.
7.
After mixing and once the blade / motor assembly is removed from the blending cup, the
blending cup can then be used directly to consume the juice / smoothie etc.
8.
The magnetic suction charging wire is required to be inserted into a standard USB Charger
Supply Unit of DC5V/1A specification, and the magnetic suction head of the charging wire is
to be placed on the charging port of the motor assembly to charge the product.
NOTE: When charging, put the blending cup flat on the table to charge. When charging, the LED
indicator will glow red, and once fully charged, the LED indicator will glow white. The product
cannot be used whilst being charged.
8
use.
th