Wiring Diagram - NuTone Roomside Series Manual

Connect 4-in. round duct.
1 9

Pull existing ducting through housing discharge

opening and tape ducting to duct connector.
connector/ducting back through opening. Engage tabs

and secure with screw from parts bag.
Install blower.
10
1
Re-install blower removed in
Step 1. Secure blower with 2
screws from parts bag. Plug
blower into black receptacle.
TM
Flex Series Fan/Light
ONLY: Plug 5-wire plug into
controller module.
Install grille.
1 11
LED Fan/Light ONLY: Snap
LED light module into inside
of grille. Note: On some
models, LED module may
already be installed.
Plug in light module. Squeeze
grille springs and insert into
slots in blower. Push grille up
against ceiling.
Depending upon
model - your grille
may look different.
2-FUNCTION CONTROL
(purchase separately)
SWITCH BOX
LIGHT
FAN
120 VAC LINE IN

ALL INSTALLATIONS

WIRING DIAGRAM

RECEPTACLE
BLACK
(LIGHT)
WHITE
RED
GROUND
RECEPTACLE
(bare)
WIRING PLATE
3
Push
2
LED
Fan/Light
ONLY
(FAN)
4
1
Continue with Step 10.
Flex
Fan/Light ONLY
TABS
4
TM
Series
If grille spring
becomes dislodged
from grille - snap it
back into place as
shown.
1100262E