Table of Contents
Advertisement
44 Analog Output
If you connected the Player's red and white AUDIO OUT or FRONT
MULTICHANNEL AUDIO OUT jacks to a Stereo as shown on page 13,
or if you connected the Player to a six-channel Receiver as shown on
page 15, choose a setting for Analog Output.
Check your Stereo or Receiver and see if it is compatible with Dolby
Surround. Then, follow these steps to choose the Analog Output setting
that is most compatible with your equipment.
1
Press SYSTEM MENU.
2
Press 9 repeatedly to select
3
Press 9 to select Analog output, then press :. Analog out-
put may be selected already. If so, just press : to continue.
4
Press 8 or 9 to select Stereo, Dolby Surr-compat (Dolby
Surround compatible), 3D sound (surround sound effect),
or Multi-channel, then press OK.
Select Stereo if your audio equipment is not compatible with
Dolby Surround, or if you connected the Player to a TV only
or to a Stereo with Right/Left Audio In jacks. When you play
Discs that were recorded in Dolby Digital 5.1, the sound will
be mixed into the appropriate Stereo sound that will be
acceptable by your two-channel TV or Stereo.
Select Dolby Surr-compat (surround compatible) if your
Stereo is compatible with Dolby Surround. If it is, usually a
Dolby Pro Logic logo will appear on the equipment.
Select 3D Sound if you did not connect any rear or surround
speakers to the Player, but still want the effect of surround
sound.
Select Multi-channel if you connected the Player to a six-
channel Receiver as described on page 15. Multi-channel is
the preset factory setting.
The Multi-channel setting means the Player's sound will be in
Dolby Digital 5.1 or DTS when available on the Disc. Dolby
Pro Logic decoding will be available on DVDs or Video CDs
that were recorded in Stereo. Dolby Pro Logic decoding is
not available with SACDs.
Z
Y
1en
1en
Digital output
Analog output
s p Stereo
G
Night mode
Clear Voice
r
Speakers
PCM Output
CD Upsampling
5
Press SYSTEM MENU to remove the menus.
will be selected.
G
, then press :.
d
1
st
Dolby Surr-compat
3D sound
Multi-channel
T-C
DISC
DIM
1
2
4
5
2-4
8
7
RETURN
0
DISC
MENU
É
OK
G
STOP
PLAY
Ç
É
SUBTITLE
ANGLE
ZOOM
REPEAT
REPEAT SHUFFLE SCAN
A-B
• Set Analog output simply in the
System Menu Bar during DVD
or Video CD playback. Press
SOUND MODE to select d.
Within five seconds, press 8 or
9 to select st, sur, 3d, or 6ch.
• If you set Analog output to
Multi-channel, adjust the speak-
ers as described on page 45.
• Multi-channel and Stereo sound
cannot be available at the same
time.
POWER
2
SOUND MODE
3
1,5
6
9
DISPLAY
SYSTEM
MENU
É
H
PAUSE
Å
AUDIO
Helpful Hints
Advertisement
Table of Contents
