Table of Contents
Advertisement
Setup
Audio setup
Analogue Output
General
Digital Audio
HDMI Audio
Video
Audio Sync
Volume
Audio
Sound Mode
Speaker Setup
Preference
Night Mode
[Analogue Output] - Adjust this setting for audio output through AUDIO OUT.
•
[Stereo] - Compress multi-channel Dolby digital sound to stereophonic sound output through
AUDIO OUT FRONT L/R.
•
[LT/RT] - Compress multi-channel Dolby digital sound to 2-channel surround sound output
through AUDIO OUT FRONT L/R.
•
[Multi Channel] - Enjoy Dolby digital sound output through AUDIO OUT 5.1 channels.
[Digital Audio] - Adjust this setting for audio output through COAXIAL/DIGITAL OUT.
•
[Digital Output] - Select a type of digital output.
•
[Off] - Disable digital output.
•
[All] - Support multi-channel audio formats.
•
[PCM Only] - Downmix to two-channel audio signal.
•
[LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate.
Note
•
[LPCM Output] setting is changeable only when [Digital Output] is set as [PCM Only].
•
The higher the sampling rate, the better the sound quality.
[HDMI Audio] - Enable or disable the audio output through HDMI cable.
[Audio Sync] - Set a delay time for audio output when you play a video disc.
[Volume] - Set the default volume level.
[Sound Mode] - Select a preset sound effect.
[Speaker Setup] - Optimize the surround effect for the connected speaker system.
•
[Front Speaker], [Center Speaker] and [Rear Speaker]
•
Select
[Large] when the speakers support the output of low frequency signal (lower than
120 Hz), otherwise select [Small].
•
Select
[Off] (This option is not available for [Front Speaker]) to mute the speaker(s).
•
[Subwoofer] - Mute or unmute the subwoofer.
•
[Speakers Volume] - Increase or decrease the volume level of each speaker.
•
[Speakers Delay] - Set the delay time for each speaker.
20
EN
Stereo
On
Off
Advertisement
Table of Contents
