Attention
· No command can be sent or received for 10 to 60 seconds after the lamp starts lighting. Try sending any command after
that period has elapsed.
· When sending several commands, be sure to wait for a response from the projector before sending the next command.
When sending commands without parameters, a colon (:) is not necessary.
Note
· If a wrong command parameter is sent, the projector will send an "ER401" or "ER402" command to the computer.
· A projector ID supported on the RS-232C interface is ZZ (ALL) and a group of 1 to 64 and 0A to 0Z.
· If a command is sent with a projector ID specified, the projector will respond to the computer only in the following cases:
If it coincides with the projector ID,
ID specification is ALL and VPS-SYSTEM is the master, or
ID specification is group and Group is the master.
5.5.
Procedure of Communication Condition Settings
(1)
Press the MENU button.
The MAIN MENU screen will be displayed.
(2)
Press the
and
(3)
Press the ENTER button.
(4)
Press the
and
buttons to select "OPTION".
buttons to select "RS232C SETTING".
13
PT-D7700U / PT-D7700E