Advertisement
Figure 4
Step 4. Install the side trim panels onto each side of fireplace face as
follows:
Brass and Stainless Trim Kits – Place side trim over channels,
then press firmly so double sided tape adheres panels to chan-
nels (see Figure 5 ).
Black Trim Kits – Place side trim panels over magnets on each
side of the fireplace face as shown in Figure 5.
Note: Magnets were installed on Step 1, Figure 2.
Right Side
Trim Panel
Figure 5
Step 5.
Brass and Stainless Trim Kits - Peel off the backing on double-
sided tape on the backside of the top trim panel. Press fit the top
channel against the top trim panel as shown in Figure 6.
Black Trim Kits – Proceed to Step 6.
Step 6. Place 2 magnets on the backside of the top trim panel as shown in
Figure 6.
LENNOX reserves the right to make changes at any time, without notice, in design, materials,
specifications, prices and also to discontinued colors, styles and products.
Consult your local distributor for fireplace code information
Printed in U.S.A Lennox Hearth Products 2004
P/N 775,175M REV. B, 12/2005
Backside of Side
Trim Panel
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
.
Backside of Top
Trim Panel
Backing
Double
Sided
Tape
Figure 6
Step 7. Place the Top Trim Panel over the Side Trim Panels as shown
in Figure 7.
Brass and Stainless Trim Kits – The metal channel should
go behind the side trim panels. Squeeze top and side trim
pieces together.
Black Trim Kits – The magnets act as support to hold the
trim panel in place.
Figure 7
Page 2 of 2
~
3"
Typical
♦Top Channel
♦Double-sided Tape
♦
Black Trim kits do not include channels or double-sided
tape. See Note on page 1.
Completed Trim Panel Installation
1110 West Taft Avenue • Orange, CA 92865
Magnet
Advertisement
