Table of Contents
Advertisement
C
Tighten the head band and secure the head pad.
Position the headset while adjusting the position of the lens
so that you can see the images clearly.
Tighten the head band at the back of your head so that the
head pad does not slip out of position.
Note
When wearing the headset with a cap, make sure there is no gap
between the brim of the cap and the head pad.
D
If you cannot view a part or any of the image, adjust
the lens justifier on either side of the lens.
Make sure the head pad does not slip out of position while
adjusting.
Adjust the left and right by the same amount so that the lens
is not tilted.
If you still cannot view images even after adjusting the lens
justifier, start again from step C.
E
Check that you can slide up the lens and secure
visibility.
If visibility cannot be secured when sliding up the lens, or if
you cannot raise the lens, start again from step A.
Caution
Do not use too much force when adjusting the position of the headset.
Note
• If the headset feels tight, replace this with the inner pad A or C. Using
a smaller inner pad loosens the headset.
➡ "Replacing the Inner Pad" p. 7
• To prevent the product from being dropped, hold the head pad in
one hand while loosening the headband and removing the headset.
18
Re-tightening Screws (BT-2000)
After using the product for an extended period, the screws securing
the lens may become loose.
Re-tighten the screws periodically using the hexagon wrench sup-
plied.
Wearing the Product
Advertisement
Table of Contents
