Connecting The Extender To External Equipment; Attaching The Extender To Infrared Controlled Av-Equipment - Philips RFX9600/05 Starter Manual

RFX9600 Starter's Guide

Connecting the Extender to External Equipment

The Extender can be connected to external equipment through the various outputs on the back
panel.
Warning Make sure that the equipment is always turned off before connecting it to the Extender.

Attaching the Extender to Infrared Controlled AV-equipment

To connect the Extender to infrared controlled AV-equipment, use one of the following cables
enclosed with the Extender:
• a Dual IR emitter;
-or-
• a mini-jack IR cable.
Insert the mini-jack in the Extender
and attach an emitter to the infrared
display of the infrared controlled
device.
Adjusting the Power Level of the IR Outputs
At the back of the Extender there are 4 dipswitches, one for each IR output. Use these dipswitches
to reduce the power level of the Dual IR emitters and the mini-jack cables.
This is useful when you suspect that the IR signal is too strong for the receiving AV-component, or
when you connect the IR port to an external IR-bus system.
5
Insert one mini-jack in the
Extender and the other in the
infrared controlled device.