Automatically Setting The Remote Control - Philips SRU 538/86 Instructions For Use Manual

SRU538_86_v6.qxd

Automatically setting the remote control

If you cannot find the right code for your brand device,
the remote control can automatically search for the right code.
Example of TV:
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The SRU 538 emits the 'switch off TV' signal for all models of TV that
are stored in the memory.
• If the device is a DVD-player or video recorder,
insert a disk or tape and start playback.
2
Then keep keys 1 and 3 on the SRU 538
pressed simultaneously for three seconds,
until the green light under TV in the selector
window flashes twice and then remains lit.
3
Press the Standby key of the SRU 538 briefly.
– The SRU 538 now starts emitting all known
'TV off ' signals, one by one.
Each time a code is sent, the green light under
TV in the selector window lights up.
4
When your TV switches off (stand-by),
you press the Standby key of the SRU 538
twice within 1 second, to confirm.
– The SRU 538 has now found a code that
works on your TV.
5
Check if you can operate all functions on your
TV with the SRU 538.
• If this is not the case, you can redo the automatic setting.
The SRU 538 will then search for a code that perhaps works
better.
– After the SRU 538 has run through all the known codes,
the search will stop automatically and the green light will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes. For
VCR and DVD this time is 2 minutes.
26-04-2005 15:29 Pagina 7
Instructions for use
1 2 3
4 5 6
7 8 9
0
SHIFT
TV VCR DVD
....
TITLE DISC
TV VCR DVD
TITLE DISC
TV VCR SAT DVD
....
2 x
7