Dyna-Glo DGPH901ATBR Manual page 7

ASSEMBLY INSTRUCTIONS
8. a. Make sure the control knob is in the OFF
position.
b. With the assistance of another person, slide
the table and the nut to the top of the post
and lightly tighten. Then raise the cylinder
housing to expose the base.
c. While one person holds the cylinder housing
in the raised position, the other person should
put the propane cylinder onto the base.
d. Connect the regulator to the cylinder valve
and turn on the cylinder valve.
e. Check the cylinder valve and regulator for gas
leakage.
f. Make sure there is no gas leakage following
the "Leak Check" instructions on page 10.
Then, the cylinder housing can be put back in
place.
9. Position the table a minimum of 5"/127mm above the
cylinder housing. Screw the plastic nut into the table by
turning it clockwise and hand tighten.
Note: Max. loading capacity of the table is 20 lbs / 9 kg.
Caution: Do not use a tool to tighten.
8
Control Knob
Table
Cylinder Housing
Cylinder Valve
Regulator and
Hose Assembly
Base
9
7