Operating Instructions - NorthStar 76136 Owner's Manual

DUTY CYCLE: This air compressor pump is capable of running continuously. To prolong the life of
your air compressor, it is recommended that a 50%-75% average duty cycle be maintained; that is,
the air compressor pump should not run more than 30-45 minutes in any given hour.
ACCESSORIES: Accessories for this unit are sold separately.
•
Risk of bursting. If any unusual noise or vibration is noticed, stop the compressor immediately and
have it checked by a trained service technician.
DAILY START-UP
1. Set the Power Switch to the OFF (0) position (A).
2. Inspect the air compressor, air hose, and any accessories/tools being used for damage or
obstruction. If any of these mentioned items need repair/replacement, contact your local
authorized dealer before use.
3. Close the drain valve (B).
4. Connect the air hose to the quick connect socket on the regulator assembly by inserting the
quick connect plug on the air hose into the quick connect socket. The quick connect socket
collar will snap forward and lock the plug into place, providing an air tight seal between the
socket and plug. To release the air hose, push the collar back on the quick connect socket
(C).
a. Firmly grasp the hose prior to inserting it into the quick connect and when removing it
from the quick connect socket.
5. Plug the power cord into the proper receptacle (D).
6. Turn the Power Switch to the ON (I) position and the compressor will start and build pressure
in the tank until cut-out pressure is reached and the unit shuts off automatically (A).
7. Adjust the regulator to a PSI setting that is needed for your application and be sure it is within
the safety standards required to perform the task. If using a pneumatic tool, the manufacturer
should have recommendations in the manual for that particular tool on operating PSI settings
(E).

Operating Instructions

⚠WARNING
Page 12 of 23