Advertisement
This document describes the SmartPanel Projector Driver for the Sharp PG-M20X projector. For more
information on configuring and using the Panel see the SmartPanel Configuration and Installation
Manual.
I. PROJECTOR CONTROL
A. Volume and Power Control
Volume control on the Sharp is relative.
B. Input Selection Mapping
The following table specifies the factory-preset input mapping for this Driver. The Configuration Utility
can be used to customize these settings your installation.
Selection 1:
DVI
Selection 2:
S-VIDEO
Selection 3:
VIDEO
Selection 4:
VIDEO
Input choices available for the Sharp with this
Driver are DVI, S-VIDEO, and VIDEO
C. Hidden Function Mapping
The following table specifies the factory preset hidden function mapping for this Driver. The
Configuration Utility can be used to customize these settings your installation.
Selection 1:
ENTER
Selection 2:
UNDO
Selection 3:
ADJUST LEFT
Selection 4:
ADJUST RIGHT
Off:
MENU
Volume Up:
ADJUST UP
Volume Down:
ADJUST DOWN
Hidden functions names are based on the Sharp
remote and controls on top of the projector. Adjust controls navigate through onscreen menus. Hidden
functions are accessed by pressing the indicated key while the holding the On key down.
The hidden functions available for the Sharp with this Driver are as follows:
MENU
ADJUST LEFT
ADJUST RIGHT
ADJUST UP
ADJUST DOWN
ENTER
DR-SHP20 – 9/17/03
ENLARGE +
ENLARGE –
FREEZE
AV MUTE
UNDO
SP Controls reserves the right to modify specifications without notice at any time.
Projector Driver Application Note
VIDEO
S-VDEO
DVI
ADJUST
LEFT
UNDO
ENTER
Sharp PG-M20x
Revision A
VIDEO
Projector
Volume
ON
Ready
Warm-up
OFF
ADJUST
ADJUST
RIGHT
UP
Projector
Volume
ON
Ready
Warm-up
OFF
ADJUST
MENU
DOWN
Advertisement
