Page 1
E N ⁄ Instructions for use ⁄ assembly instructions A XOR Starck V D E ⁄ Gebrauchsanleitung ⁄ Montageanleitung 12112003 I N S T A L L A T I O N...
Page 2
⁄ The plumbing codes applicable in the respective countries must be observed. glass spout must be cleaned in regular intervals (at least once per week), and daily in subtropical and tropical countries. ⁄ Please pay attention to the fact that the mixer is equipped with a laminar spray. This enhances the natural aspects of water as element of life. ⁄ The glass spout must be treated with care. As this laminar spray does not contain any air, we recommend the use of very deep washbasins to reduce splashing. For further recommendations please consult the Axor Mixer⁄ Wash Basin Matrix. To reduce splashing, you can also change the point where the water jet hits the M A I N T E N A N C E (see page 10) washbasin. To do so, swivel the spout or loosen the spray former to disable the vortex. (see page 05 Fig. A - C) The check valves must be checked regularly according to DIN EN 1717 in ⁄ The drain valve must only be used as intended. It is not allowed to attach other accordance with national or regional regulations (at least once a year). objects to the drain valve, for example a semi-pedestal. T E C H N I C A L D A T A...
Page 3
Lebenselements Wasser unterstreicht. stimmung mit nationalen oder regionalen Bestimmungen auf ihre Funktion Da es sich bei einem Laminarstrahl um einen Strahl ohne Luftbeimischung handelt, geprüft werden (mindestens einmal jährlich). empfehlen wir zur Vermeidung von Spritzwasser die Verwendung von extra tiefen Waschbecken. Weitere Informationen können Sie der Axor Armaturen-Waschtisch-Matrix entneh- men. S E R V I C E T E I L E (siehe Seite 11) Weitere Möglichkeiten zur Vermeidung von Spritzwasser sind die Veränderung des Auftreffpunktes vom Wasserstrahl im Waschbecken durch Schwenken des Auslaufs S O N D E R Z U B E H Ö R (nicht im Lieferumfang enthalten) oder das Deaktivieren des Wirbels durch Lösen des Strahlformers. (siehe Seite 05 Strahlkörper #92341000 (empfohlen bei Betriebsdruck < 0,15 MPa)
Page 4
3 Nm 120° SW 10 mm SW 19 mm SW 24 mm 4 Nm 95° 4 Nm 120°...