5. Lift the I/O board out of the computer.
Installing the input and output board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the input and output board and provides a visual representation of the installation procedure.
Steps
1. Locate the I/O board on your computer.
2. Align and place the I/O board into the computer.
3. Install the two (M2x2) screws that secure the I/O board to the computer.
4. Connect the cable to the computer.
5. Install the three (M2.5x5) screws that secure the hinge to the computer.
Disassembly and reassembly
45