Operation - Bissell CLEANVIEW POWERBRUSH 37E3G User Manual

Operation

Ready Tools™
Your carpet cleaner comes equipped with a hose
and at least one attachment for cleaning stairs,
upholstery, and more.
Important! If using the machine to clean
upholstery, check upholstery tags.
1. Check manufacturer's tag before cleaning. If
the tag says "Dry Clean Only," do not proceed.
Do not use on velvet or silk. If manufacturer's tag
is missing or not coded, check with your furni-
ture dealer.
2. Check for colourfastness in an
inconspicuous place.
3. If possible, check upholstery stuffing. Coloured
stuffing may bleed through fabric when wet.
4. Plan activities to give upholstery time to dry.
5. Thoroughly remove dirt, debris and pet hair.
Use a vacuum brush attachment and crevice tool
to clean in fabric folds and tufts.
6. To begin cleaning with attachments, follow
the instructions on page 7 for filling the 2-in-1
water tank.
7. Set the ReadyTools dial to the TOOLS setting.
This will allow spray and suction from the hose.
8. Attach the cleaning tool to the end of
the hose.
9. Clean by pressing the spray trigger to spray
solution onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the spray trigger to suction
dirty water. Continue to clean in the area,
working in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove tool and
attach the HydroRinse™ Tool to the cleaning
hose.
11. Hold the hose and HydroRinse attachment in
an upright position. Then hold down the trigger
to rinse the hose for 30 seconds. After use, the
HydroRinse tool can be clipped to the hose in
between use.
12. Before wrapping hose onto tool rack, lift
end of hose and stretch out to ensure all water is
cleared from hose.
IMPORTANT
Check for colourfastness in an inconspicuous place. If
possible, check upholstery stuffi ng. Coloured stuffi ng
may bleed through fabric when it becomes wet.
Manufacturer's tag
7.
11.
12.
www.BISSELL.com.au
9