Advanced Settings; Change Master Pin; Registration - Philips CD1503B/05 User Manual

8

Advanced settings

8.1

Change Master PIN

The Master PIN is used for registration/
unregistration of handsets. The default
Master PIN number is 0000. The
maximum length of the Master PIN is 8
digits. This PIN is also used to protect the
settings of your handset. Your handset
will prompt you whenever the PIN is
required.
Note
The default pin code is preset to 0000. If
you change this PIN code, keep the PIN
details in a safe place where you have easy
access to them. Do not lose the PIN
code.
m
1
Press
:
to
ADVANCED SET
<
, scroll
OK
<
and press
2
Enter the current Master PIN when
prompted and press
confirm.
• The PIN entered will be shown as
asterisks (*) on the screen.
3
Enter the new PIN and press
.
to confirm
• A validation tone is emitted and the
screen returns to previous menu.
Tip
If you forget your PIN, you will need to
reset your phone to its default settings.
See "Reset unit" on chapter 8.5 for more
details.
26
key in idle mode, scroll
and press
:
to
CHANGE PIN
.
OK
<
to
OK
<
8.2

Registration

The procedures described below are the
procedures that you will find in your
handset. The procedures may vary
according to the handset you want to
register. In this case, please refer to the
manufacturer of the additional handset.
Additional handsets must be registered to
the base unit before you can use them. Up
to 4 handsets can be registered to one
base station.
To register your handset manually:
The Master PIN is required before you
can register or unregister handsets.
Note
By default, the Master PIN is 0000.
1
On the base station, press and hold
V
2
On the handset, press
scroll
press
REGISTER
Note
If no action is taken on the handset within
10 seconds, the registration procedure will
be aborted. If this happens, repeat Step 1.
3
Enter the Master PIN when prompted
and press
OK
Note
By default, the Master PIN is 0000.
4
WAITING
screen.
Note
If no action is taken on the handset within
10 seconds, the registration procedure will
be aborted. If this happens, repeat Step 1.
If no base is found within a certain period,
for approximately 5 seconds.
:
to
ADVANCED SET
< :
, scroll
OK
<
and press
<
to confirm.
OK
_ _ is displayed on the
Advanced settings
m
key,
and
to
.
OK