Mechanical Installation - CAL Controls CAL 3300 User Manual

LEVEL 4
LEVL 4
Access to level 4 is gained through UEr in level 3. Press and hold
seconds.
Enter level 4 at Lock , release and together. Display reads LoCK nonE
Program security using Lock
Select from three Lock options: Press and hold , press
LEV.3
locks level 3 and 4 only- Technical Functions.
LEV.2 locks levels 2, 3 and 4 only - Configuration and
Technical Functions.
ALL locks all functions LoCK ALL
Note: Locked functions and options may be read.
Press to access following functions
Function Options
ProG [Auto] StAY
Program mode auto-exit switch
Auto-exit returns display to normal if 60 seconds of key inactivity, select StAY to disable
no.AL [oFF] on
Disable SP2 alarm annunciator -AL-
Select on to disable -AL-
di.SS dir 1 to 32
Display sensitivity
dir = direct display of input 1 = maximum, 32 = minimum sensitivity
dEr.S 0.1 to 1.0
Derivative sensitivity

MECHANICAL INSTALLATION

The Controllers are designed to be mounted either in a 1/16 or a 1/32 DIN panel cutout.
The units are sleeve mounted with the front bezel assembly rated NEMA4/IP66 provided
that:
the panel is smooth and the panel cutout is accurate;
the mounting instructions are carefully followed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
and for 10
to index.
[Factory settings] shown in brackets
[6]
[0.5]
DIN PANEL CUTOUT
1/16 DIN: 45.0mm +0.6 / 0.0 wide, 45.0mm +0.6 / 0.0 high
1/32 DIN: 45.0mm +0.6 / -0 wide, 22.2mm +0.3 / -0 high
Maximum panel thickness 9.5mm
Minimum spacing 20mm vertical, 10mm horizontal
MOUNTING
To mount a Controller proceed as follows:
1 Check that the controller is correctly orientated and then slide the unit into the cutout.
2 Slide the panel clamp over the controller sleeve pressing it firmly against the panel until
the controller is held firmly.
3 The controller front bezel and circuit board assembly can be unplugged from the sleeve.
Grasp the bezel firmly by the recesses on each side and pull. A screwdriver can be used
as a lever if required.
4 When refitting the bezel assembly it is important to press it firmly into the sleeve until the
latch clicks in order to compress the gasket and seal to NEMA4X/IP66.
CLEANING
Wipe down with damp cloth (water only)
Note: The controller should be isolated before removing or refitting it in the sleeve, and
electrostatic precautions should be observed when handling the controller outside
the sleeve.
DIMENSIONS: MODELS 3300 / 9300 / 9400
Model Bezel*
Width Height Width
3300 51.0 28.5
9300 51.0 51.0
9400 51.0 51.0
Dimensions in mm
* includes gasket
Behind Panel Overall Behind panel
Height Length Length*
44.8 22.0 116.2 106.7
44.8 44.8 116.2 106.7
44.8 44.8 116.2 106.7
9