Installing And Operating Your Fridge - Telefunken CF-33-100-W User Manual

Table-top refrigerator
Table of Contents

Advertisement

Available languages

Available languages

• Do not touch frozen goods with wet hands. Do not eat ice-cream
or ice cubes immediately after you have taken them out of the ice-
making compartment.
• This product is intended to store fresh food and drinks. Store fresh
food and drinks short-term.
• Do not store frozen food in the ice-making compartment.
• Do not re-freeze frozen goods after they have melted. This may cause
health issues such as food poisoning.
• Do not use electrical devices, defrosting sprays or pointed or sharp-edged objects (such
as knives or forks) to remove the ice.
• Do not cover the body or top of fridge with lace. This affects the performance
of your fridge.
• Secure any accessories in the fridge during transportation to prevent damage
to the accessories.

Installing and operating your fridge

Before starting to use your fridge, you should pay attention to the following points:
• The operating voltage for your fridge is 220-240 V at 50Hz.
• We do not accept responsibility for any damages that occur due to ungrounded usage.
• Place your fridge where it will not be exposed to direct sunlight.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores,
and at least 5 cm away from electrical ovens.
• Your fridge should never be used outdoors or exposed to rain.
• When your fridge is placed next to a deep freezer, there should
be at least 2 cm between them to prevent humidity forming on the
outer surface.
• Do not place anything on your fridge, and install your fridge in
a suitable place so that at least 15 cm of free space is available
above it.
• Use the adjustable front legs to make sure your appliance is level and stable. You can
adjust the legs by turning them in either direction. This should be done before placing
food in the fridge.
• Before using your fridge, wipe all parts with a solution of warm water and a teaspoon
of sodium bicarbonate, then rinse with clean water and dry.
Place all parts in the fridge after cleaning.
• Install the plastic distance guide (the part with black vanes at
the rear) by turning it 90° (as shown in the figure) to prevent the
condenser from touching the wall.
• The refrigerator should be placed against a wall with a free space
not exceeding 75 mm.
EN - 21 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cf-33-100-r

Table of Contents