Advertisement
3
You can store the appliance in the following ways:
-
Put the appliance in upright position. To attach the nozzle to the appliance, insert the ridge on
the nozzle into the storage slot. (Fig. 29)
Note: To ensure stable parking of the telescopic tube, adjust the tube to the shortest length.
-
Store the appliance and its accessories in the box or plastic storage container (specific types
only). To find out how to do this, look at the storage figure at the beginning of this user manual.
Accessories
If you have any difficulties obtaining filters or other accessories for this appliance, please contact the
Philips Consumer Care Centre in your country or consult the worldwide guarantee leaflet.
Dustbags
-
Philips Classic s-bag® synthetic dustbags are available under type number FC8021.
-
Philips Clinic s-bag® high filtration synthetic dustbags are available under type number FC8022.
-
Philips Anti-odour s-bag® synthetic dustbags are available under type number FC8023.
Note: Please visit www.s-bag.com for more information about the s-bag®.
Clean Air hEPA outlet filter
-
Clean Air HEPA outlet filters are available under service code 4222 459 48841.
super Parquet nozzle pads (specific types only)
-
Super Parquet nozzle pads are available under type number HR8041.
Environment
-
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 30).
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care Centre in your country (you find its phone
number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country,
go to your local Philips dealer.
The storage box is not covered by the terms of the international guarantee.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
Problem
The suction
power is
insufficient.
Possible cause
The dustbag is full.
The motor protection filter is
dirty.
The Clean Air HEPA outlet
filter is dirty.
Solution
Replace the dustbag (see chapter
'Replacement').
Clean the motor protection filter (see
chapter 'Cleaning').
Replace the Clean Air HEPA outlet filter (see
chapter ' Replacement).
English
11
Advertisement
