Bosch GAM 220 Professional Original Instructions Manual page 16

Hide thumbs Also See for GAM 220 Professional:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13
16 | English
The measured value of the angle w between the base leg and fold-out leg is
indicated in the display. The required angle v between the base leg and leg
extension is calculated as follows:
 v = 180° – w
w
GAM 220 MF: "Simple Mitre" Operating Mode
The "Simple mitre" measurement is used to calculate the cutting angle MTR
when two workpieces with the same mitre have to form any outer angle x°
smaller than 180° (e.g. for skirting boards, banister columns or picture
frames).
The "simple mitre" operating mode is activated by pressing the but-
ton MTR1 (14). The displayed value is always used for the calculation of the
MTR. If a saved value is being displayed (indicator (a) flashes), the calcula-
tion will be performed with the saved value regardless of the position of the
legs.
When workpieces are to be fitted into a corner (e.g. for skirting boards),
measure the corner angle x° by positioning the fold-out leg and the base leg.
For given angles (e.g. picture frames), open the fold-out leg and the base leg
until the required angle is indicated in the display.
The mitre angle MTR, by which the two workpieces are to be shortened, is
calculated. For these mitre/bevel cuts, the saw blade is perpendicular to the
workpiece (the bevel angle is 0°).
Press the button MTR1 (14). The calculated horizontal mitre angle MTR,
which has to be set on the chop and mitre saw, and the indicator MTR will be
shown on the display.
1 609 92A 58K | (18.11.2019)
v
v
Bosch Power Tools

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gam 220 mf professional

Table of Contents