Eaton Cooper Power Series Installation Instructions Manual
15, 25, and 35kv
Hide thumbs
Also See for Cooper Power Series:
- Installation, operation and maintenance manual (189 pages) ,
- Installation, operation and maintenance instructions (128 pages) ,
- Installation and operation instruction manual (52 pages)
Related Manuals for Eaton Cooper Power Series
Summary of Contents for Eaton Cooper Power Series
- Page 1 COOPER POWER Loadbreak Apparatus Connectors SERIES Effective August 2018 MN650064EN New Issue 15, 25, and 35kV Cleer Bail Installation Instructions...
-
Page 2: Disclaimer Of Warranties And Limitation Of Liability
CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES. In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or otherwise for any special, indirect, incidental, or consequential damage or loss whatsoever, including but not limited to... - Page 3 Contents DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii SAFETY FOR LIFE .
-
Page 4: Safety Information
FOR LIFE FOR LIFE Eaton meets or exceeds all applicable industry standards relating to product safety in its Cooper Power™ series products. We actively promote safe practices in the use and maintenance of our products through our service literature, instructional training programs, and the continuous efforts of all Eaton employees involved in product design, manufacture, marketing, and service. -
Page 5: Product Information
The Eaton Cooper Power series Cleer™ grounding elbow CLEERCHAIN is a tool used to provide a visible ground on Eaton Cooper Power series 600 A, 15, 25 and 35 kV Cleer Loadbreak Connector Systems. It is designed to be installed directly... - Page 6 15, 25, and, 35kV Cleer Bail Step 1 Install 600A grounding elbow Install grounding elbow onto Cleer bushing according ● ● to the instructions included with the Cleer grounding elbow (MN650056EN). WARNING CLEERBAIL and CLEERCHAIN are required when a Cleer 4/0 grounding elbow (GE6354) is mated with a Cleer Insert (LBI635) on a 35kV Tee (DT635) in locations where available fault currents are in excess of 16kA RMS symmetrical to 25kA RMS symmetrical .
- Page 7 (Refer to Figure 8). One or two links may be free if using an Eaton Tee. ● ● More or fewer links may be needed if using competitor WARNING Tee.
- Page 8 Eaton.com/cooperpowerseries © 2018 Eaton All Rights Reserved Printed in USA Eaton is a registered trademark. Publication No. MN650064EN For Eaton‘s Cooper Power series product August 2018 information, call 1-877-277-4636 or visit: All trademarks are property www.eaton.com/cooperpowerseries. MN650064EN Rev. 1 of their respective owners.