Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 SUPPORT Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 INFORMATION Web site: www.blackbox.com • E-mail: info@blackbox.com...
Weight: RM082A: 66 lb. (29.9 kg); RM084A, RM088A: 70 lb. (31.8 kg); RM086A: 75 lb. (34 kg); RM089A: 80 lb. (36.2 kg) Overview The Freedom Rack Plus neatly houses computer equipment. It’s available in five models: three tapped (round- hole) models and two untapped (square [M6]-hole) models. The part numbers for each model are listed below.
Page 4
FREEDOM RACK PLUS Assembly The Freedom Rack Plus ships unassembled. Follow the instructions in this section to assemble it. 1. Using (2) ⁄ -16 x 1" screws, (2) ⁄ lockwashers, and (2) ⁄ -16 nuts, connect the flat horizontal bar to the front side of the first pair of vertical rails.
Page 5
FREEDOM RACK PLUS 4. The rack’s depth can be adjusted in 1" (2.5-cm) increments. Connect the first set of sliding top horizontal rails together using (4) ⁄ -20 x 0.75" bolts and (4) ⁄ -20 nuts. Using (4) more ⁄...
Page 6
FREEDOM RACK PLUS ⁄ -20 nuts Sliding top horizontal rails ⁄ -20 x 0.75" bolts Figure 5. Horizontal rails adjusted to 28.5" (72.4 cm) deep. ⁄ -20 nuts ⁄ -20 nuts ⁄ -20 x 0.75" bolts Sliding bottom horizontal rails ⁄...
Page 7
FREEDOM RACK PLUS 5. Once the sliding top and bottom horizontal rails are assembled, you’re ready to connect them to the rack’s vertical rails. Use (8) ⁄ -16 x 1" screws, (8) ⁄ lockwashers, and (8) ⁄ -16 nuts. Figures 8 and 9 show the installation for two depth ranges.
Page 8
FREEDOM RACK PLUS ⁄ -16 x 1" screws ⁄ -16 x 1" screws ⁄ -16 nuts ⁄ lockwashers ⁄ -16 nuts ⁄ lockwashers Vertical rail Vertical rail Top horizontal rails Vertical rail ⁄ -16 x 1" screws Vertical rail ⁄...
Page 9
FREEDOM RACK PLUS 6. In step 3, you connected the horizontal bars to the remaining pair of vertical rails. Now, connect these two vertical rails to the rack assembly, as shown in Figures 10 and 11. You’ll need (8) ⁄...