PAC Cylinder Mate CM6000 Installation Instructions

P
ERFORMANCE
www.pactoolmounts.com
Cylinder Mate P/N CM6000
For additional assistance call (888)-514-0083 between 8AM-5PM EST or email: info@pactoolmounts.com
To avoid the risk of personal injury, property damage or product damage, please use the included
fasteners for mounting.
* This product must be securely mounted to a stable surface and material.
* This product contains enough mounting hardware to assemble two Cylinder Mates to each other.
* Misuse of this product may result damage or injury and void warranty.
* Verify that all fasteners have been tightened securely before putting into service.
* Note: All included fasteners may not be utilized for every installation.
Option 1: Single Cylinder Mate CM6000 Mounting
Position Cylinder Mate in desired location with the non-windowed side on the primary
mounting surface. (see Figure 1A) Using the included hardware, attach the cylinder mate with (4) Carriage
Bolts P/N 2037 and (4) Nuts P/N 2042 to the mounting surface. Installer to locate and drill (17/64) holes for
mounting.
FIGURE 1A
A C
DVANTAGE OMPANY
(STANDARD VERSION)
CAUTION
page1

INSTALLATION INSTRUCTIONS

Items Required for this step
PAC Fastener
Kit
P/N 7037
The CM6000 Cylinder Mate can accept P/N CM-
20 strap. Contact a PAC representative for more
information.
Remove the attaching screw and replace strap.
Strap Mounting Screw
CM-20 Locking
Strap
FIGURE 1B
4-3-17
INS-CM6000
Qty
¼-20 x ¾
Carriage Bolt 4
P/N 2037
¼-20 Flanged Nut
4
P/N 2042
not
Small 7/16
included
ratcheting Wrench