Page 1
77R. Read, understand and keep this manual in a safe and convenient place. - Do not operate PJ-77/PJ-77R until you read and understand the instructions in this manual. - Horizon International Inc. shall not be liable for incidental consequential damages resulting from : improper or inadequate maintenance by customer;...
Page 2
Safety Precautions - The signal word WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. - The signal word CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices.
1. Before You Begin 1. Before You Begin 1-1 Specifications ................... 2 1-2 Major Machine Parts Descriptions ............3 1-3 Accessories ....................4...
1. Before You Begin 1-1 Specifications Max. Sheet Size : 318 x 470 mm (12.5” x 18.5”) Min. Sheet Size : 148 x 210 mm (5.8” x 8.3”) Pile Height : 90 mm (3.5”) Separation : 30 mm (0.8”) Machine Weight : 40 kg (88.2 lb) Machine Dimensions : 490 x 400 x 460 mm (19.4”...
Page 7
1. Before You Begin 1-2 Major Machine Parts Descriptions [PJ-77R] Delivery Unit (On the Collator) Magnet Guide Side Guide (Fix Position) End Stopper Operation Panel This stopper must be adjusted according to size of sheets. Cables Tray Down Pedal Tray Up Pedal...
1. Before You Begin 1-3 Accessories Long Wrench (5 mm) (5064-5113) 1 pc Delivery Smoother (S) (M001625-02) 1 pc Magnetic Guide (M014685-00) 1 pc Delivery Smoother (L) (M014687-00) 1 pc...
2. Installation and Operation Instructions 2-1 Before Installing PJ-77/PJ-77R Tray Unit Change installing position of tray unit ac- cording to types of collators. Hook Installing positions can change by chang- ing hook installed PJ-77/PJ-77R. Connector Lower position : VAC Series...
Prepare room at the delivery side of collator where PJ-77/PJ-77R can be installed. Loosen lock knob and fix delivery direc- DOWN Lock Knob tion down. Install PJ-77/PJ-77R at the delivery side of 10 mm collator. Then divide 10 mm clearance between delivery roller and tray. NOTE PJ-77/PJ-77R has casters.
2. Installation and Operation Instructions 2-3 Setting Up Stopper Guide 2-3-1 Setting Up End Stopper and Magnet Guide Loosen two lock knobs and slide end 5 mm Clear- Lock Knobs Side guide stoper to right or left so that the clearance ance between sheet edge and table edge will be 5 mm.
2. Installation and Operation Instructions 2-4 Setting Switches Set full tray detector switch. Full Tray Lamp Towards You : detector OFF Towards Other Side : full tray detector ON NOTE When full tray detector switch is on, lamp of full tray lamp turns red after tray lowers at Full Tray Detector Switch the lowest position, then collating stops automatically.
- VAC,MC, HRC/HAC series collators start collating automatically if belt is running on ascending tray. (PJ-77) Tray Up Pedal (PJ-77R) Tray Up Pedal 2-6 Adjustment of Vibration WARNING Balance Weight Be sure to unplug cables before vibration is adjusted in balance weight.