Advertisement
as far as it will go and twist the blade.The housing will begin to
split.
C
3
Remove the screwdriver and repeat the above instruction
using the other slot located on the opposite side of the handle.
Twist the blade and the housing will continue to split.
C
4
Now insert the screwdriver into the middle slot located on the
top front part of the handle as shown and push the blade in as
far as it will go.
C
5
Now use the screwdriver as a lever to pry the 2 handle
sections apart.
C
6
Pull the 2 handle sections completely apart.
C
7
Insert the screwdriver underneath the electronic circuit board
in multiple places.
ENGLISH
11
Advertisement
