Pellet Loading Procedure; Startup Stage - Ferroli EASYFIRE 29 Installation, Use And Maintenance Instructions

EASYFIRE 29 - 35 - 39

7.3 PELLET LOADING PROCEDURE

Do not load non-conforming fuels in the hopper.
Do not put foreign bodies such as containers, boxes, bags, metals, etc., in
the hopper.
The use of poor quality or non-conforming pellets will damage and
compromise the unit's operation, invalidating the warranty and relieving the
manufacturer of any liability.
Load the pellets as follows:
Step Action
1 Open the pellet hopper door on the back of the boiler.
Manually load the pellets.
2
Note: loading can be done with the machine on or off.
3 Pour the pellets in, taking care not to overfill the hopper.
The use of pellets with characteristics different from those tested by the
technician during first lighting involves a new setting of the boiler pellet
loading parameters; this operation is not covered by the warranty.
The pellet hopper lid must always remain closed; it must only be opened
when loading fuel.
The bags of pellets must be kept at least 1.5 m from the boiler.

7.4 STARTUP STAGE

Light the boiler as follows:
Step Action
Press button "P4" for 3 seconds.
1 Note: the message "START" will appear on the display. This stage is automatic and managed
entirely by the electronic controller without the possibility of changing the parameters.
Alternatively, the boiler can be lit as follows:
Step Action
Press buttons "P4" and "P5" simultaneously for 3 seconds.
Note: the message "AWAITING REQUEST" appears on the display. With this mode
1
the boiler switches to standby status and carries out the lighting-start stage only if
a request for heat is recognised, e.g. to heat the water or for DHW (if available).
Clock
H O temperature
2
Boiler - Puffer
Dialogue box
The boiler carries out the startup stages in sequence according to the procedures defined by
the parameters that manage levels and times, reaching the work condition unless anomalies
or alarms occur, according to the following table:
EN
cod. 48427B011_01/18_Hardware / M.Software 6.0
Water
temperature
Button P4
71