Connection To External Equipment; Connecting A Pc; The Touch Screen Connections - Philips 190S6FGT/00 User Manual

6. CONNECTION TO EXTERNAL EQUIPMENT

1
1
2
3
3
6.1

CONNECTING A PC

Caution:
Before connecting the cables to the touch screen monitor and PC, be
sure the computer is turned off and the power cable of the touch screen
monitor is not plugged in.
6.1.1

THE TOUCH SCREEN CONNECTIONS

The following cables need to be connected to the touch screen monitor:
■
Power cable
■
VGA signal cable
■
Speaker cable
Note:
The serial interface cable is pre-connected to the monitor. Length of the
serial cable is 1.3 meter.
To connect the cables to the touch screen monitor:
1 Remove the cover plate at the back of the touch screen monitor;
4x screws.
2 Connect the female end of the power cable to the power port on
the touch screen monitor (1).
3 Connect the VGA signal cable to the VGA-Connector on the touch
screen monitor (2). Secure the cable by turning the screws on the
connector clockwise.
4 To use the built in speakers, you need to connect the speaker cable.
Connect the speaker cable to the speaker port inside the back of the
touch screen monitor (3).
5 Remount the cover plate at the back of the touch screen monitor
using the 4x screws.
Note:
The cover plate can be positioned with the cable conduct up or
down. Select the required position.
17
User Manual 190S6FGT