Advertisement
EBSKBN, EKSKBN
MEMO
1) Current measurement
To measure VDD current, please cut the shorting 1pin and 2 pin of CN6. And connect
an ampere-meter between the pins of connector CN6 to monitor the current directly.
2) About VDD power supply
When you use external power supply, please supply power from 1pin and 2pin of CN13.
On this case, you cut short circuit 1pin and 2pin of CN5 and should separate 3V3OUT
of FT232RQ.
3) USB to serial UART interface
It needs to install driver of FT232RQ to use USB for UART interface.
The drivers are available on FTDI website.
http://www.ftdichip.com/Drivers/D2XX.htm
In addition, by the application development, please assign GPIO as follows.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
CN6
CN5
CN13
GPIO
P0.05
P0.06
P0.07
P0.08
TAIYO YUDEN CO., LTD
TAIYO YUDEN CO., LTD.
UART
RTS
TX
CTS
RX
27-Feb.2019 Ver.1.0
6/7
Advertisement
