Table of Contents
Advertisement
BATTERIES
(supplied or optionally available)
You can use the following batteries with this CD-player:
Normal batteries type LR6, UM3 or AA,
Alkaline batteries type LR6, UM3 or AA (preferably Philips)
• PHILIPS rechargeable batteries, type AY3365
Helpful Hint:
– Old and new batteries should not be combined.
– Remove batteries in the order ( 1, 2, 3) as shown if
they are empty or if the player is not going to be used
for a long time.
For battery case only
Inserting rechargable batteries
1
Push •• ç•• to open the CD lid.
2
Open the battery compartment (inside the CD player) and insert 2 x PHILIPS
rechargeable batteries, type AY3365.
Battery indication
The approximate power level of your batteries is shown in the remote control display.
Battery full
Battery two-thirds full
Battery one-third full
Battery low or empty. When the batteries are low,
beep tone sounds repeatedly.
Batteries contain chemical substances, so they should be disposed
of properly.
USING THE EXTERNAL BATTERY CASE
(AA batteries not included)
The external battery case allows you to:
• increase playtime by using fully charged rechargeable batteries and new AA
alkaline batteries at the same time.
• have a convenient backup power supply if your
rechargeable batteries are flat. Operate the set on
just 2 x AA batteries instead.
1
Push on PUSH/ OPEN to open the battery case,
and lift off the case cover as indicated.
2
Insert 2 alkaline batteries, type AA/ LR6/ UM3 with
correct polarity, and replace the case cover.
3
Connect the battery case to the EXT BATT jack on the set.
Helpful Hint:
– When using the external battery case, avoid jolting the player and swinging the
case. Sudden movements may cause damage to the external battery connection
and pose a hazard.
– This player includes a motor mechanism that extends battery lifetime by vary-
ing the motor's rotation rate. Motor noise may increase when the rate changes.
If the noise bothers you, use the AC/DC adapter to power the player. The motor
rotation rate does not change when operating on AC power.
Recharging the ECO-PLUS NiMH battery on board
Recharging works only on players supplied with the rechargeable ECO-PLUS
NiMH battery AY3365.
1
Insert the rechargeable ECO-PLUS NiMH battery AY3365.
2
Connect the power adapter to the 4.5V DC jack of the player and then to the
wall outlet.
Charging appears.
• Recharging stops after a maximum of 7 hours, or when you start playback.
3
When the battery is fully recharged,
play.
Helpful Hint:
– It is normal for the batteries to become warm during recharging.
– If the batteries become too warm, recharging will be interrupted for
approximately 30 minutes.
– To ensure proper recharging on board, take care that contacts are clean.
– Use only the ECO-PLUS NiMH battery AY3365.
Handling instructions
• Recharging already charged or half-charged batteries will shorten their
lifetime. We therefore recommend that you let the rechargeable ECO-PLUS
NiMH battery run till it is completely empty before you recharge it.
• To avoid a short circuit, do not let the battery touch any metal object.
• If the battery becomes empty soon after recharging, then either its contacts
flashes, and the
are dirty or it has reached the end of its lifetime.
For best playback quality connect the set to AC/DC.
only the AY3170 adapter (4.5 V/ 300 mA direct
current, positive pole to the center pin). Any other prod-
uct may damage the player.
1
Make sure the local voltage corresponds to the AC/
DC adapter's voltage.
2
Connect the AC/ DC adapter to the 4.5V DC jack of the player and to the wall
outlet.
Helpful Hint:
Battery playtime
Average playing time of 2 alkaline AA and/ or AY3365 rechargable batteries
under normal conditions:
2 x AA alkaine + Ni-MH
2 x AA alkaine, Power Saving mode
2 x Ni-MH, Power Saving mode
and Batt Full appears in the dis-
AC/ DC ADAPTER
(supplied or optionally available)
Use
Always disconnect the adapter when you are not using it.
Audio CD MP3/ WMA
65 hr
46 hr
20 hr
FM Tuner
102 hr
108 hr
70 hr
73 hr
30 hr
30 hr
Advertisement
Table of Contents
