Using The Alarm - Philips AJ100/37B Owner's Manual

STORING AND USING PRESET STATIONS
You can store up to a total of 5 FM radio stations in the memory.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2 To store a preset, hold down briefly on a PRESET button 1-5 until you hear a double
beep.
™ Display shows the preset number of your station.
3 Repeat steps 1 and 2 to store your other stations.
• You can overwrite a preset station by storing another frequency in its place.
4 Press a PRESET button 1-5 to listen to a preset station.

USING THE ALARM

GENERAL
Two different alarm times can be set. This can be useful when you need to be
woken up at a different time e.g. during the week and at the weekend:
• ALARM - radio mode
• ALARM - buzzer mode. The gentle wake buzzer alarm increases its beep tone
frequency within seconds.
SETTING THE ALARM TIME AND MODE (See 3 )
1. Check the radio is switched off.
2. Press ALARM
™ Display: OFF disappears under the respective
3. Press and hold SET AL
4. Hold down or press HR + or MIN + repeatedly to set and adjust the hours
and minutes respectively. Release HR + or MIN + when you have reached
the correct setting.
5. After both the hours and minutes are set, press SET AL
confirm the setting.
Helpful hints:
– If you have selected ALARM
station before turning off the set.
– If you set and activate the same time for both alarms, only the ALARM
activate at the set time.
or ALARM to on.
or SET AL
, make sure you have properly tuned to a
AL
or
until alarm time digits flash.
or SET AL
AL
icon.
to
will be