Basic Features; Illumination Brightness; Setting The Clock - Philips AJ100/12 User Manual

SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your preset stations, alarm and clock
time settings to be stored for up to 3 minutes when there is a power interruption e.g.
AC power failure. The complete clock radio and backlight illumination will be switched
off.
If power supply returns after 3 minutes and the display shows:
• clock time blinking - indicates you need to re-adjust the clock time.

BASIC FEATURES

Reset
Should your set receive external interference e.g. static electricity from carpets, thun-
derstorms, etc. RESET allows you to clear all previous settings and start up again.
• Use a ballpoint pen to press the RESET hole found on the bottom of the set.

Illumination brightness

Press REPEAT ALARM /
• The brightness of the display can be adjusted:
➟
Bright

SETTING THE CLOCK

The time is displayed using the 24-hour clock.
1. Check the radio is switched off.
2. Press SET TIME to enter the clock setting mode.
3. Hold down or press HR + or MIN + repeatedly to set and adjust the hours
and minutes respectively. Release HR + or MIN + when you have reached
the correct setting.
4. Press SET TIME to confirm.
BRIGHTNESS CONTROL
➟ ➟
Low Off
once or more.
Bright .