Connecting To The Network - Paradyne FrameSaver 9120 Installation Instructions Manual

Connecting to the Network

1. Insert the 8-pin connector on the
RJ48C network cable into the NET
interface.
2. Insert the other end of the cable into
the RJ48C modular jack.
Connecting to an M66 Block
Use the optional T1 mass termination cable to connect up to seven NAMs to an M66
block. The T1 mass termination cable is a 5-foot RJ48H cable consisting of a 50-pin
plug-to-seven RJ48C plugs. See the RJ48H Connector for T1 Mass Termination Cable
table on page 20 for pin assignments.
1. Insert up to seven of the RJ48C plugs on the RJ48H network cable into the NET
interface(s).
2. Insert the 50-pin plug end of the cable into the M66 block.
RJ48C
Plugs
Plug Number
Label
NAMs
RJ48C
Jack
M66 Block
50-Pin Plug
97-15749
7
T 1
N A
M
N E
T
NET
D B
M
D S
X
97-15053-01