Sun Visor; Vanity Mirror - BMW i8 COUPE Owner's Manual

CONTROLS
4. Likewise, press and hold the button of the
desired function on the hand-held transmit‐
ter.
5. Release both buttons as soon as the interior
mirror LED flashes more rapidly. The LED
flashing faster indicates that the button on
the interior mirror has been programmed.
The system can then be controlled by the
button on the interior mirror.
If the LED does not flash faster after at most
60 seconds, change the distance and repeat
the programming starting with step 4. Several
more attempts at different distances may be
necessary. Wait at least 15 seconds between
attempts.
Canada: if programming with the hand-held
transmitter was interrupted, hold down the in‐
terior mirror button and repeatedly press and
release the hand-held transmitter button for
2 seconds.
Operation
WARNING
Body parts can be jammed when operating re‐
mote-controlled systems, such as the garage
door, using the integrated Universal Remote
Control. There is a risk of injury or risk of dam‐
age to property. Make sure that the area of
movement of the respective system is clear
during programming and operation. Also follow
the safety information of the hand-held trans‐
mitter.
The system, such as the garage door, can be op‐
erated using the button on the interior mirror
while the engine is running or when the standby
state is switched on. To do this, hold down the
button within receiving range of the system until
the function is activated. The interior mirror LED
stays lit while the wireless signal is being trans‐
mitted.
178
Interior equipment
Online Edition for Part no. 01402989296 - II/18
Deleting stored functions
All stored functions will be deleted. The func‐
tions cannot be deleted individually. Press and
hold the two outer buttons on the interior mirror
simultaneously for approximately 20 seconds un‐
til the LED on the interior mirror flashes rapidly.

Sun visor

Glare shield
Fold the sun visor down or up.

Vanity mirror

A vanity mirror is located in the sun visor behind
a cover.
Sockets
General information
The lighter socket can be used as a socket for
electrical equipment when standby and drive-
ready state are switched on.
The total load of all sockets must not exceed
140 watts at 12 volts.
Do not damage the socket by using non-com‐
patible connectors.
Safety information
WARNING
Devices and cables in the unfolding area of the
airbags, such as portable navigation devices,
can hinder the unfolding of the airbag or be
thrown around in the car's interior during un‐
folding. There is a risk of injury. Make sure that
devices and cables are not in the airbag's area
of unfolding.