Selecting A Different Track; Finding A Passage Within A Track; Programming Track Numbers; Playing A Cd - Philips AZ1022/12 User Manual

CD Player

Playing a CD

• This CD player plays Audio Discs including
CD-Recordables (CD-R) and CD-Rewritables
(CD-RW).
• MP3, CD-ROM, CD-I, CDV,VCD, DVD or
computer CDs are not possible for playback.
IMPORTANT!
CDs encoded with copyright protection
technologies by some record companies may
be unplayable by this product.
1 Adjust the Source selector to CD.
2 Open the CD door, and insert a CD with
the printed side facing up, then press the CD
door gently to close.
➜ Display shows --, and later the total
number of tracks.
2/;
3 Press to start playback.
4 To pause playback, press 2/;.
➜ Display: 2
flashes. (See 4)
5 To resume, press
6 To stop CD playback, press 9.
Helpful hints:
CD play will also stop when:
– you open the CD door;
–
you select TUNER or TAPE/ OFF sound
source;
–
the CD has reached the end.

Selecting a different track

∞/ §
• Press
once or repeatedly until the
desired track number appears in the display.
• In the pause/stop position, press
playback.
(See 3)
2/;
again.
2/;
to start
Finding a passage within a
track
1 During playback, press and hold
➜ The CD is played at high speed and with
reduced volume.
2 When you recognize the passage you want,
∞ §
release or
Helpful hints:
–
When your searching reaches
last track, the CD goes to stop mode.
Programming track num-
bers
You may store up to 20 tracks in the desired
sequence. If you like, store any track more
than once.
1 In the stop position, press PROG to
activate programming.
➜ Display: PROG and 00 flash.
∞ §
2 Press or
number.
3 Press PROG to store the desired track
number.
➜ Display: PROG and 00 flash for you to
program the next track..
4 Repeat steps 2 to 3 to select and store all
desired tracks in this way.
➜ If you attempt to store more than 20
tracks, no track can be selected and the
display shows - - - - .
5 To play your program, press 2/;.
Helpful hints :
–
When playback of your program comes
to the stop position, your set will return
to normal playback.To re-enter program
mode, press PROG in the stop position.
∞
to resume normal playback.
the end of the
to select your desired track
§
or .
5)
(See