Selecting A Different Track; Programming Track Numbers; Playing A Cd - Philips AZ1123W/05 User Manual

CD Player

Playing a CD

• This CD player plays Audio Discs including
CD-Recordables (CD-R) and CD-Rewritables
(CD-RW).
• MP3, CD-ROM, CD-I, CDV,VCD, DVD or
computer CDs are not possible for playback.
IMPORTANT!
CDs encoded with copyright protection
technologies by some record companies may
be unplayable by this product.
1 Adjust the Source selector to CD.
2 Open the CD door.
3 Insert a CD with the printed side facing up,
then press the CD door gently to close.
➜ Display shows --, and later the total
number of tracks. (See 2)
4 Press 2; to start playback.
5 To pause playback, press 2;.
➜ Display: 2 flashes. (See 3)
6 To resume, press 2; again.
7 To stop CD playback, press 9.
Helpful hints:
CD play will also stop when:
–
you open the CD door;
–
you select FM,MW or OFF;
–
the CD has reached the end.

Selecting a different track

• Press ∞/ § once or repeatedly until the
desired track number appears in the display.
• In the pause/stop position, press 2; to start
playback.
Finding a passage within a
track
1 During playback, press and hold ∞ or § .
➜ The CD is played at high speed and with
reduced volume.
2 When you recognize the passage you want,
release ∞ or § to resume normal playback.
Helpful hints:
–
When your searching reaches the end of the
last track, the CD goes to stop mode.
Programming track num-
bers
You may store up to 20 tracks in the desired
sequence. If you like, store any track more
than once.
1 In the stop position, press PROG to
activate programming.
➜ Display: PROG and 00 flash. (See 4)
2 Press ∞ or § to select your desired track
number.
3 Press PROG to store the desired track
number.
➜ Display: PROG and 00 flash for you to
program the next track.
4 Repeat steps 2 to 3 to select and store all
desired tracks in this way.
➜ If you attempt to store more than 20
tracks, no track can be selected and the
display shows flashing --.
5 To play your program, press 2;.
Helpful hints :
–
When playback of your program comes to
the stop position, your set will return to nor-
mal playback. To re-enter program mode,
press PROG in the stop position.