Hardware Installation; Installation Complete; Technical Support - D-Link DUB-E130 Quick Installation Manual

PROdUCT SETUP

HARDWARE INSTALLATION

Step 1:
Plug the DUB-E130's USB connector into an available USB Type-C port on your computer.
Step 2:
Attach an Ethernet cable to the Ethernet port on the DUB-E130.
Step 3:
Attach the other end of the Ethernet cable to your network switch, or router.
Step 4:
Your operating system will detect the new hardware and prompt you for the drivers if necessary. (See
previous page for driver installation instructions.)
For Windows 10, 8; Mac OS 10.11.6 and above:
No software installation or configuration necessary.
For Windows 7 and Vista:
The driver software installation will start automatically.
For Windows XP:
The Found New Hardware Wizard box will pop up. Select Yes, this time only and click
Next to continue.
On the next screen, choose the option to install the software automatically and click Next to
continue. Windows will find and install the correct driver automatically. Click Finish when complete.

INSTALLATION COMPLETE

When the installation of the DUB-E130 is complete, the LINK LED (light on the top right of the RJ-45
Ethernet port) should be solid green, indicating a good physical connection between the DUB-E130
and the network, and will flash when data is being sent or received. The Connection Speed LED (light
on the top left of the RJ-45 Ethernet port) will light solid orange to indicate a Gigabit connection, or
remain unlit to indicate a 10/100 Mbps connection. If both LEDs are unlit, there may be a problem
with the physical connection. Check the connections between your DUB-E130, the computer, and the
network. Verify that your network switch or router is powered on.
For technical documentation and additional drivers please visit:
https://www.dlink.com/support

TECHNICAL SUPPORT

DUB-E130
dlink.com/support
3