Start Inhibitor - Husqvarna LC 247Li Workshop Manual

7.11 Start inhibitor

7.11.1 To remove and install the start inhibitor
1. Remove the 4 screws and remove the cover on the
left side of the start inhibitor. Pull the cables out of
the start inhibitor.
2. Disconnect the cables.
3. Remove the screw and remove the motor brake
handle.
34 - Repair instructions
4. Remove the right side of the start inhibitor.
5. Remove the drive bail wire (only LC 347VLi, LC
347iVX and LC 353iVX).
6. Install the start inhibitor in the opposite sequence.
Use the correct torque. Refer to
page 13 .
Servicing data on
361 - 001 -