Setting Up Adsl Service; Checking Led Indications - ADC 400F User Manual

S U
ETTING P
The service provider sets up the ADSL parameters for your service. The modem must have
the ADSL SYNC LED lit before you can connect sessions with your service provider. Verify
SYNC in the following section,
C LED I
HECKING
The section below describes LED indications for all operational modes. LEDs on the modem
front panel provide continual status at-a-glance for network and modem connections.
LED State
PWR On green
Off
LINK On green
Off
TX Flashing green
Off
RX Flashing green
Off
COL Flashing green
Off
SYNC On green
Flashing green
Off
TX Flashing green
Off
RX Flashing green
Off
MAR On green
Off
Megabit Modem 400F User Manual
ADSL S
ERVICE

"Checking LED Indications."

NDICATIONS
Description
Modem has power.
Modem does not have power.
A PC, hub, or other network device is connected to the modem
10/100BASE-T interface.
No device is connected to the modem 10/100BASE-T interface.
Modem is transmitting data to devices on the LAN.
Modem is not transmitting data to the LAN.
Modem is receiving data from devices on the LAN.
Modem is not receiving data from the LAN.
Collision detected on the 10/100BASE-T port..
No collisons detected.
ADSL transceiver is synchronized and in normal operation mode.
ADSL transceiver is in a start-up sequence.
ADSL transceiver is not synchronized or is in a mode other than
normal operation or startup.
Modem is transmitting data to the service provider.
Modem is not transmitting data to the service provider.
Modem is receiving data from the service provider.
Modem is not receiving data from the service provider.
ADSL margin is at or above the value set by the service provider.
ADSL margin is below the value set by the service provider.
LAN
ADSL
Chapter 3: Installing the Modem
15