Advertisement
Quick Links
Advertisement
Summary of Contents for Agilent Technologies 19199N
- Page 1 Installation Guide NPD/ECD Chemical Filters Accessory 19199N...
- Page 2 © Agilent Technologies 2000 Safety Information Safety Symbols All Rights Reserved. Reproduction, The Agilent Technologies NPD/ECD Warnings in the manual or on the adaptation, or translation without Chemical Filters meets the following IEC instrument must be observed during all permission is prohibited, except as allowed...
-
Page 3: Preparing The Instrument
Installing the NPD/ECD Chemical Filters Accessory 19199N Preparing the Instrument WARNING Hazardous voltages are present in the instrument whenever the power cord is connected. Avoid a potentially dangerous shock hazard by disconnecting the power cord before working on the instrument. - Page 4 Installing the NPD/ECD Chemical Filters Accessory 19199N Preparing the Instrument Remove the autosampler tray from its mounting bracket by simultaneously lifting and turning the two tray locks that hold it in position, then sliding the tray away from the instrument.
- Page 5 Installing the NPD/ECD Chemical Filters Accessory 19199N Preparing the Instrument Note The filter(s) can be installed on the flow panel in either a front or back position. Chemical filter assembly Chemical filter mounting bracket Rear mounting Front mounting location location If an auxiliary flow panel is not installed, loosen the screws in the front or back mounting location on the flow panel.
- Page 6 Installing the NPD/ECD Chemical Filters Accessory 19199N Preparing the Instrument 10. Disconnect the outlet fitting plate from the top of the filters. Remove the flow lines from the filters. Route these lines to the detector flow manifold. Hydrogen, NPD (5890 only)
- Page 7 Installing the NPD/ECD Chemical Filters Accessory 19199N Preparing the Instrument 11. Disconnect the outlet fitting plate from the side of the detector flow manifold. Remove the flow lines from the detector flow manifold. Outlet fitting plate NPD hydrogen (marked with red) 12.
- Page 8 Installing the NPD/ECD Chemical Filters Accessory 19199N Preparing the Instrument 13. Turn on the supply gases connected to the Detector Support Gas fittings. Leak test the connections at the flow manifold block and the top of the detector chemical filters.
- Page 10 Printed on recycled paper. This product is recyclable. Agilent Technologies, Inc. Printed in USA Dec 2000 19231-90767...