Internal Tape Drive Installation
Locate the SCSI ID jumpers on the rear panel of the drive as shown in
Use
Figure 8: SCSI ID settings
Note:
above 6 is not recommended.
Terminating the Tape Drive
If the DLT VS 40/80 GB tape drive is the only SCSI device – other than the SCSI
host adapter – on the selected server, it must be terminated. Likewise, if the DLT
VS 40/80 GB tape drive is the last device on the selected server SCSI bus, it must
be terminated.
The DLT VS 40/80 GB tape drive ships with a ribbon cable that is already
terminated as shown in
sure that the cable is terminated at each end.
32
Figure 8
to select the desired SCSI ID.
SCSI ID
0
Jumper
Block
SCSI ID 7 is reserved for the controller. The SCSI ID can be set up to 15, but a SCSI ID
Figure
1
2
3
9. If you use a cable other than the one provided, be
DLT VS 40/80 GB Tape Drive Reference Guide
Figure
4
5
6
7.