Advertisement
Figure 1
1. Roller shaft
2. Ball stud
3. Ball-joint receiver
4. Jam nut
5. Pull-link extension
6. Bolt
2.
Remove the bolts and roller shafts securing the
anti-scalp rollers and the pull-link assemblies to
each carrier frame
3.
Disassemble the pull-link assemblies
4.
Thread the previously removed jam nut onto
each of the new longer pull-arm extensions
and onto the existing pull-link and bushing
assemblies
(Figure
7. Flat washer
8. Spacer
9. Bushing
10. Pull-link assembly
11. Anti-scalp roller
(Figure
1).
(Figure
2)
g218544
1. Roller shaft
2. Ball stud
3. Ball-joint receiver
4. Jam nut
5. Long pull-link extension
6. Carriage bolt
7. Locknut
8. Flat washer
1).
5.
Assemble the new longer pull-arm extensions to
the existing pull-link assemblies and ball-joint
receiver assemblies
the jam nuts at this time.
6.
Mount the appropriate link bracket (left or right)
and a previously removed anti-scalp roller to
the end of each front carrier frame with a new
carriage bolt and the previously removed roller
shaft. Position the brackets as shown in
2.
7.
Mount a pull-link assembly to the outside of each
link bracket with a bolt (3/8 x 1-1/2 inches), flat
washer, bushing, the previously removed spacer
and flat washer, and a new locknut
Note:
Make sure that the bushing is inside the
pull-link assembly.
8.
Slide back the sleeve on the ball-joint receivers
and install the receivers onto the ball studs
(Figure
2).
9.
Mount a basket onto the carrier frame.
10.
Adjust the pull arms until there is a 6 to 10 mm
(1/4 to 3/8 inch) clearance between the lip of the
basket and the reel blades.
2
Figure 2
9. Spacer
10. Bushing
11. Pull-link liner
12. Pull-link assembly
13. Link bracket
14. Bolt (3/8 x 1-1/2 inches)
15. Anti-scalp roller
(Figure
2). Do not tighten
(Figure
g218546
Figure
2).
Advertisement
