Connecting A Non-Usb Device; Using Ac Power - Philips MCM239D/12 User Manual

Installation

Connecting a non-USB device

It is possible to use an additional appliance, e.g.
TV, VCR or CD recorder with the set. On
MCM239D, you can playback music from an
external source.
1
Insert one plug of the audio cable (not supplied)
to the socket AUX IN at the rear panel of the
main set.
2
Connect the other end of the audio cable to the
AUDIO OUT terminal of the additional
appliance.
3
Select AUX mode on the set.
Helpful hints:
– Always refer to the owner's manual of other
equipment for complete connection.
14

Using AC power

1
Make sure all the connections have been made
before switching on the power supply
2
Connect the supplied AC/DC power adaptor to
the DC jack (located on the rear panel of the
main set) and to the wall socket. This switches on
the power supply.
To avoid damage to the set, use only the
adaptor supplied.
When MCM239D is switched to standby, it is still
consuming some power. To disconnect the
system from the power supply completely,
remove the power plug from the wall
socket.
The type plate is located on the rear of the
set.
For users in the U.K.: please follow the
instructions on page 2.
Warning!
To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it (not available for all versions).
This product complies with the radio
interference requirements of the European
Community.
CAUTION
Visible and invisible laser radiation. If the
cover is open, do not look at the beam.
High voltage! Do not open. You run the risk
of getting an electric shock.
The machine does not contain any user-
serviceable parts.
Modification of the product could result in
hazardous radiation of EMC or other
unsafe operation.