Patriot 1.0M Manual page 7

Non-Penetrating Mount (optional)
1. Assemble the Non-Penetrating mount per the supplied instructions to provide the mast for
the mount installation.
2. Refer to the ballast chart for the required ballast to be placed in the Non-Pen Ballast Trays.
NOTE: Higher elevation angles can use less ballast. If there are any possible future elevation
adjustments that could result in a lower elevation angle use the 22 deg elevation angle from
the chart for the ballast requirement!
90cm Ballast Chart
Elevation Ballast Required (lbs)
(deg)
80
22
207
40
162
60
93
28 lb
4x8x16 Block
9 blocks per tray
(use single tray
PTX-NP300S)
Wind Speed (mph)
100 125
391 679
305 529
176 305
100cm Ballast Chart
Elevation Ballast Required (lbs)
(deg)
80
22
259
40
202
60
116
120cm Ballast Chart
Elevation Ballast Required (lbs)
(deg)
80
22
411
40
321
60
185
(use single tray
PTX-NP 300S)
W ind Speed (mph)
100 125
480 826
374 644
216 372
(must use dual tray
PTX-NP300D)
Wind Speed (mph)
100 125
733 1236
572 964
330 556
Add-on Dual Tray
(if necessary)
7
7