Table of Contents
Advertisement
System Menu Options
➜
STEREO: Left mono sound will send output
signals to Left speaker and Right mono sound
will send output signals to Right speaker.
➜
L-MONO: Left mono sound will send
output signals to Left speaker and Right speaker.
➜
R-MONO: Right mono sound will send
output signals to Left speaker and Right speaker.
3D PROCESSING
Provides a virtual surround sound experience
using just two speakers.
➜
OFF, CONCERT, LIVING ROOM,
HALL, BATHROOM, CAVE, ARENA and
CHURCH.
HDCD
Sets the audio output cutoff frequency point
when playing an HDCD disc.
➜
OFF, 44.1K and 88.2K.
NIGHT MODE
In this mode, the high volume outputs are
softened and low volume outputs are brought
upward to an audible level. It is useful for
watching your favourite action movie without
disturbing others at night.
➜
ON: Select this to level out the volume. This
feature is only available for movies with Dolby
Digital mode.
➜
OFF: Select this when you want to enjoy the
surround sound with its full dynamic range.
AUDIO SYNC
Sets the audio output delay time if the video
playback is slower than the audio output.
●
Select this option and then use 1 2 keys on the
remote control to set the delay time for the
audio output between 0~200ms.
VIDEO SETUP PAGE
COMPONENT
Sets the video output according to your video
connection. This setting is not required if you are
using the VIDEO jack (yellow) to connect the
DVD micro system to your TV.
22
➜
S-VIDEO: Select this if you have connected
the DVD micro system to your TV using S-Video
jack.
➜
Pr/Cr Pb/Cb Y: Select this if you have
connected the DVD micro system to your TV
using Component video jacks.
TV MODE
Selects interlace or P-SCAN video output mode
when Pr/Cr Pb/Cb Y is selected.
➜
P-SCAN and INTERLACE.
In the progressive scan mode, you can enjoy the
high quality picture with less flickers. It only
works when you have connected the DVD
player's Y Pb Pr jacks to your TV that supports
the progressive video input. Otherwise, a
distorted picture will appear on the TV. For
proper progressive scan set up, see "Getting
started-Setting up Progressive Scan feature".
QUALITY
This menu helps you to set the video quality.
SHARPNESS
Adjusts the sharpness level.
➜
HIGH, MEDIUM and LOW.
BRIGHTNESS
Adjusts the brightness level. Range: -20-+20.
CONTRAST
Adjusts the contrast level. Range: -16-+16.
GAMMA
Adjusts the gamma level.
➜
HIGH, MEDIUM, LOW and NONE.
HUE
Adjusts the hue level. Range: -9-+9.
SATURATION
Adjusts the saturation level. Range: -9-+9.
LUMA DELAY
Adjusts the luma delay.
➜
0 T and 1 T.
Advertisement
Table of Contents
